Fellow Woodworkers:
My name is Dan Locaputo, and I am a member of the Cincinnati Woodworkers Club, (CWC) in Cincinnati, Ohio.
I invented the patented Automatic Flute Spacing Jig which I am trying to promote. I did a demonstration of my jig at the CWC, and many advanced woodworkers were impressed enough, and purchased my jig. Since, I do not have any middle men, I can sell my jig at a much lower cost. They are selling in some Woodcraft stores for $44.99.
This jig will space up to (7) seven flutes on boards up to (12) twelve inches wide, without any measuring. The jig is made of 1/4″ x 1-1/2 “anodized aluminum. There are (3) three zinc plated bushings that comes with the jig, which allows 1/4″, 3/8”, and 1/2″ flutes to be made. I am proud to say they are made in USA, and will last a lifetime.
I would really appreciate it, if you would send my web address to all of you Woodworking members. The usual cost of my jig is $30.00 plus S&H. However, for Woodworking Clubs, I am willing to sell my jig for $25.00 plus $7 S&H.

Thank you.

My web address is: www.drlgroupllc.com My web site also shows many useful tips for the router table.

Your fellow woodworker,
Dan Locaputo email: dlocaputo@aol.com
phone: (513) 451-1599